1996BlackBauer Posted May 17, 2016 Share Posted May 17, 2016 Hey guys, Over the weekend I finally got around to putting the rest of the Franken motor back together, and finally got the the new lightweight Exedy flywheel on with a new Exedy Stage 1 clutch and pressure plate. Now I know I can set the clutch up the same as it was when I originally got the car, but the owner(My Best Friend), didn't like how it released so far up in the travel. So how can I adjust it so it releases lower, and how do I make sure I did it right? Specs: 1995 Impreza L Wagon 5 speed Cable clutch new clutch(stage 1) new flywheel(light weight) 2.5L Block with 2.2L heads DOES NOT have hill hold If you need any more info, I would be happy to add that as well. Thank you in advanced! Quote Link to comment Share on other sites More sharing options...
RLD Posted May 17, 2016 Share Posted May 17, 2016 I'm going to assume that it had a cable operated clutch cable? If you want the clutch to grab off of the floor you would usually do it by the book. Loosen the clutch cable on the fork until there's play and tighten it up until there's about 1/8 (don't quote this I believe that's the tolerance) play on the fork. 1 Quote Link to comment Share on other sites More sharing options...
Fairtax4me Posted May 17, 2016 Share Posted May 17, 2016 Loose cable = low release Tight cable = high release 1 Quote Link to comment Share on other sites More sharing options...
1996BlackBauer Posted May 17, 2016 Author Share Posted May 17, 2016 Awesome! Thanks guys, I'll play around with it and see what happens. But I'll keep in mind that loose, will be lower. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.