Factory manual codes/terms ??

Anyone understand the code used in FSM for such things in wiring electrical

Above a sketch is (MIC-9)

I think Male Inline Connector 9 pins? It sounds right description of the diagram drawing wise

But the diagram showing the actual layout of the corresponding plug is (MIC-9M)

A round connector plug (ECJ-8F)

It has 8 pins in total

And they be Female

Circular plug

But at Check Connector III (MIC-17F)

I think we're Female

Yes 17 pin size plug

Inline Connector just two rows

Then the Yellow wire at coil negative is (LA105) no dash between alpha and numeric. Same at Engine Ground

Another check terminal in the loom is a single , white, female, plastic has (MCA-1F)

At the two wire knock sensor is a Circular plug

(ECJ-2) Circular and 2 wire

Should not have C for Circular if C is for Connector so think both incorrect

Might be one for General Disorder??

Edited May 18, 20205 yr by Step-a-toe