Jump to content

Customized Swing Arms

Recommended Posts

Posted (edited)

So I'm considering building my BRAT with new swing arms / A.
I'm going to widen the position a little (less than an inch so as not to mess too much with axles) to add some extra adjustment points for camber and caster and perhaps adjust the lower spindle mount to allow a better / sturdier ball joint mount.

Once I draw it, I'll get a picture up.

I'll probably use the mounts in the factory so that bushings don't change or I can go with an upgraded bushing design.

It's based on what I can easily get.

Any suggestions before I draw?where am i

Edited by chris1

Share this post

Link to post
Share on other sites

Check Whiteline for parts that may fit - much less expensive and less hassle than rolling your own.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now