I am finishing up a full rotisserie restoration on a 1978 
Subaru Brat.  The only thing thats missing is the pistons.  I am unable to find them anywhere.  Anybody have any ideas?  

ITM 2666 pistons.  .020 over preferred.  But .040 in a pinch.

Any suggestions would be helpful.

Thanks

73mako

I ended up having to use .040 over pistons due to lack of supply.  The machine shop said there were no problems.  I will keep you up to date on how it all turns out when I am finished.  Hopefully by the end of May.

I know this is an older thread but I’m wondering how the 40 over pistons worked? I’m in the same boat. I only need to bore 20 but 40’s are all I can find. I just hate boring that far if I don’t need to but it looks like I don’t have a choice.