revbill Posted September 5, 2004 Share Posted September 5, 2004 With the help of a lot of information from this board (thanks for all the help!) and some books/FSM info, I was able to get the engine out and replace the head gaskets on an '85 4WD GL wagon. When I put the engine in, it started, but I can't get it in gear. The clutch moves like it did before, but it doesn't feel like it is disengaging. Does anyone have a suggestion for what to do now? The cable doesn't seem loose--did I damage the clutch putting the engine back in? It just grinds when I put the clutch in and try to put it in gear. Link to comment Share on other sites More sharing options...
subawoohoo Posted September 5, 2004 Share Posted September 5, 2004 i think you just need to adjust your cable. i doubt you damaged anything, as long as it slid in there easily. Do the gears engage when the engines off?? if so it'll be your clutch. usually however it doesnt grind unless your trying to go into reverse, but in my opinion, thats what it is. i myself just got a car for a few bucks because the owner thought the clutch/tranny was toast, but all it needed was adjusted. give it a shot. i think thats all it will be. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now