Guys,

 

I finally got around to installing a trailer hitch on my '96 Outback wagon today. I ordered a DrawTite hitch from Drawtite-hitches.com. The install was a snap and everything fit perfectly. Only took about 30 minutes for the hitch and 30 minutes for the wiring. I found a plug in the back near the drivers side rear tail light that had outputs for the trailer lights. Wiring up the adapter was a breeze. Can't say enough good things about the drawtite hitch....very sturdy, fit perfectly and you can't even see it under the bumper unless the draw bar is attached. I did not have to cut or remove anything to do the install. You do have to drill two 1/2 inch holes but that about it....otherwise just bolt it on. If anyone plans to do this, feel free to ask any questions you might have. I could not find much info. about a hitch install and I thought about doing a DIY writeup. After doing the install, I don't think there is much need for a DIY....it's THAT simple.

 

Todd

I have the same hitch, I think. The only thing I don't like about it is the support member for the exhaust pipe goes under the exhaust pipe. I had to bend my tail pipe some to not have it rattle on the hitch crossmember. You don't have this problem?

What class hitch?

What class hitch?

 

Mine's a Class II.

 

-Mark