From the AA site;

" EJ 1990-2005 Outbacks, Legacy, Forrester, and Baja, Imprezza

 

EJ series lift: This is the newest addition to the allied Armament family. It comes as 4" that replaces the factory 2.5" lift for the outback and 4" lift for the Legacy. It retains stock geometry in the front and adds minimal strain in the rear (almost none). It is based on lowering front and rear struts via strut extensions and lowering blocks for front and rear sub assemblies. (bolt on kit) " Has anyone actually done this lift? I'm wondering if there are any special tools required, or if it could be done by someone without a AutoShop full of stuff.

IIRC this was used on a 1st gen Outback that was entered into the DARPA Challenge. I tried googling for more info but haven't found much yet, mostly just about the electronics on the car, not mechanical stuff.

 

Steve