Hey - I just blew the left front axle stub seal on the tranny, sending copious amounts of gear oil all over my driveway - anybody know the part #'s for generic (NAPA, CarQuest, etc) replacements - I need the car sooner than the dealer will be able to get me a seal (pref by the end of tomorrow morning) - carquest # would be nice, because they have a distribution hub near here

thanks

BECK/ARNLEY Part # 0523504

Transmission Seal, Right;Drive Axle Flange;1 Per Car

 

BECK/ARNLEY Part # 0523505

Transmission Seal, Left;Drive Axle Flange;1 Per Car

 

For some reason they have different part numbers for each side.

 

You should check out www.rockauto.com they are the best with most prices. Even with shipping included.

 

Hopefully that works.

thanks - I really dont have time to wait for shipping - I am going to try to have it fully operational about 12 hrs from now, luckily I had tomorrow off anyway. Thanks a ton for the info though.

Matt

 

BTW - I replaced the seals in december - I noticed there is a directional groving to the seal - hence why the different part #'s - I think I didn't have the seal seated properly when I installed it, hence the early failure

 

thanks again

Reviving this old post is a direct result of doing a search, so don't complain about it.

 

Anyway, I am now confronted with this same problem. Has anyone found a supplier other than Beck Arnley?? First I want to fix this on Tuesday or Wednsday so ordering it isn't the way I want to go, and Rock Auto seems to have them in stock but want over $9.00 to ship two little seals that cost half that!

 

They also show the same part number for 4-speed and 5-speed.

 

Also, how difficult are they to get out? After the axles out of the way of course.

With some more searching I've found the procedure, but nothing on the seals.