brus brother Posted June 17, 2008 Share Posted June 17, 2008 How do you get to the screws behind the door pull on the 05+ Outbacks. The handle has seams in the back but I can't figure out how to pop it off and I'd rather not trash it. Quote Link to comment Share on other sites More sharing options...
sea#3 Posted June 19, 2008 Share Posted June 19, 2008 How do you get to the screws behind the door pull on the 05+ Outbacks. The handle has seams in the back but I can't figure out how to pop it off and I'd rather not trash it. This may help you , see attached SEA#3 Handle removal.doc handle removal 2.doc Quote Link to comment Share on other sites More sharing options...
ShawnW Posted June 20, 2008 Share Posted June 20, 2008 They break fairly easily and thats a perfect diagram. Quote Link to comment Share on other sites More sharing options...
brus brother Posted June 20, 2008 Author Share Posted June 20, 2008 Thanks for the directions and tips. I have tried the twist method with no luck. There appears to be two seams on the back of the handle and I am assuming that this it is only the front section that roatates away? If so, the offset in the seams appears counterintuitive to the direction of twisting. I haven't tried the "pry bar" method yet but thanks for the "delicato" warning Shawn. Quote Link to comment Share on other sites More sharing options...
sea#3 Posted June 20, 2008 Share Posted June 20, 2008 I have found that these work well . the one with ring on the end grabs the edge of the handle very welll http://www.amazon.com/Actron-CP5011-Specialty-Molding-Removal/dp/B000VYBLJ4 SEA#3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.