Skip to content
View in the app

A better way to browse. Learn more.

Ultimate Subaru Message Board

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

95 Legacy L fog lights

Featured Replies

My as of now does not have fog lights.. however I brought some fog lights from the Japanese version that are the projector kind..

 

My car still has the fog light covers on them If it was fog light ready the plugs would be behind the covers right? I don't see any so I guess I will be running a harness to them?

They were not prewired, all MY95-99 had a kit with all the relays wires and switches to install them.

 

I think I have a complete wire set I pulled out of my old 95 after an accident (minus a couple of vampire clips and plugs). PM me if you're interested and I'll dig it out and give you a rundown of what I have and anything additional you might need.

 

I even have the installation instructions.

  • Author

I need help.. so my fogs arrived and I removed the front bumper skin off.. however I don't see anything that the fogs mount onto for the car... I have the bolts and everything but I can't figure out where.

 

DSCF0046.jpg

 

DSCF0045.jpg

I'm having a little trouble with orienting your photos but you don't have to remove the whole skin. Just cutout the square blanks in the plastic and directly above the opening there should be 2 holes above there that are vertical (heading straight up) in the inner bumper beam. The original light kit came with self tapping nut headed screws that you screw in the holes and they have threaded center holes that the bolts go into. If the nuts are missing you may have to use a bolt and washer setup or something else but I don't think those holes pass all the way though.

 

Do you have pictures of the lights bolts, and brackets on them?

 

Here's a picture of my 95, should look similar to what yours is:

 

95Frt.jpg

Edited by Suzam

  • Author

well turns out because I had no fogs from the factory I had no bracket... So I had to drill two holes and used a total of 4 5/16's 2" long bolts and nuts with locking washers.

 

Finally got it in.. putting the bolt in was a pain because the washer was hitting on the bumper part in front of the bumper beam.

 

DSCF0048.jpg

OK good. If your still interested I'm gonna dig through the storage above my garage and find the wiring stuff tomorrow if i get up there before it gets too hot.

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.