hancho3

OK, so I have an '81 BRAT and the ball joints are a different type than I have came across in most threads, I removed the knuckle in order to replace wheel bearings, cv shafts, tie rods, and ball joints, I have the new bearings and CV shafts installed and the knuckle is on the shaft and strut, how in the world to i get the 3 bolt ball joint on the control arm and the knuckle. So i am basicly looking for an order of reassembely. anything helps thanks, Kurt

I have removed the steering knuckles on my 81 brat and I got new bearings and seals for them, the book says I need some special tools to do this. Can I just get the bearings pressed out and pressed in? Also does the outer CV axle end need to be pressed in the bearings? thanks, Kurt