How and where can i access this. I tried to get it to work tonight, the pump still pumps. Turned it on and it puked it all out the quarter pannel. Somethings not hooked up. Oh and a side question. Anyone have a good way to stick the interior pannels back under the rubber seal around the glass.

 

Ben

I have the exact same issue. Pump pumps, but it all comes out the rear quarter panel. I have not looked at it too much yet...

if they are the same as the ea81 wagons, the tubing goes up the back pillar, and theere is a ball check-valve there so that the fluid doesn't drain back... what I've had happen, is the ball valve gets crusted up (age, and non-use) and will not allow fluid to go through. hoses crack from age, and then when you try and pump it, it either pushes the cracked hose off, or seeps through the crack...

 

best bet, is to start at the filler and remove panels, and follow the line to find the bad valve and/or loose/cracked hose connection...

I guess its safe to assume that the tank is more then likely behind that wheel well pannel. Looks like a pain in the butt to take off. Yea the bottom of my hose wasnt attached to anything, but i need to check it out. Would be nice to have that this winter.