Jump to content
Ultimate Subaru Message Board

#1 On Heater Power Dial Won't Work


Recommended Posts

Not sure if this is fixable, but when I turn my heater/defroster etc on, I have to go to at least the second setting before anything starts coming out. Setting's 2,3,4 work but not 1. The lights for the buttons come on when I switch it to #1, just no air comes out. I would like to have that spot working since all the rest are quite loud when just cruising.

 

Any ideas?

 

~Thanks!

Link to comment
Share on other sites

There is a resistor coil that controls the lower fan settings.

 

The resistor is located under the passenger kick panel, to the left of the fan motor. There is a plastic tab on the lower panel that fits into a slot. The slot is on the resistor itself, it drops out with 2 screws.

 

If you remove it, you will likely find one of the coils are broken. You can solder in a resistor if you know what resistance is needed for each speed

Link to comment
Share on other sites

Find one in a junkyard and replace the entire thing. Subaru used the same unit over many years and many models.

 

No sense in soldering in a resistor; the wire coil is a very high wattage and low resistance wire. You're not going to find a replacement resistor that will fit and work for you.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...