changed coil , fuel filter, plugs / wires, oem, crank sensor, getting fuel , but seems no spark on crank, any more suggestions ????????????before i quit and torch it

There are a few possibilities. Besides determining that there's no spark, what electrical tests have you done? Do you have a voltmeter available? If so, check at the coil and igniter, to begin. See http://endwrench.com/images/pdfs/DirectIgnition.pdf

 

Note that there are errors in the "DirectIgnition.pdf" info. In the "Ignition Coil Testing" section, the terminal numbers listed are reversed between the primary and secondary; however, the diagram is labeled correctly.

ok,think i found the problem cam sensor, but had to order one, as much $$$$ as i spent i should had it towed to a shop

Edited January 24, 201016 yr by 86subaru

i have several cam sensors but no crank sensor, are they the same sensor

No, they look about the same. But the connector is a little different.

yes, of course i did not have the parts, thing is the sensor was hard to get out , like stuck in there, thanks

Haha, yea, they can be hard to get out sometimes. You just need to work it back and forth while pulling out on it.