Ive had a intake manifold and wiring harness for a 93 subaru legacy sitting im my garage for a while just incase I wanted to put an EJ22 into my offroader.

 

About two weeks ago I grabbed a long block from pull and save.however, stupid me I forgot to grab the bolts for the intake manifold-and the exhaust manifold gaskets...

 

what is the thread size for those bolts?Length would be helpful but If I can find a bolt that will thread all the way down to the bottom I can figure out the length needed with my tape measure...

 

Also would permatex ultra grey work as a gasket instead of the specified gaskets for the intake manifold?I'm down to my last $20 unless I can find another "handyman" type temp job...

12 mm I don't have the pitch. They are about 2" long. I'd just hit the yard and pull another set.

the yard is 2 hours one way.

I could mail you a used set if you want $15.00