i just replaced my , expansion valve ,and my receiver dryer.. Also my revolution sensor on my 2002 h6 motor. With no help from a damn manual. They dont exhist! everything went well. accept i forgot to mark the colors of the wires down that i pulled out of the Revolution sensor, so that when i reinstalled them in the new plug i would know what their configuration is..The wires going to the rev sensor stay attached to the top of the compressor by a clip and plug. There colors are black ,yellow and black with a stripe i beleive.. Can anyone look under there hood for me and see what there wire location is for the Rev sensor plug on top of the A/C compressor by color and location for the 3.0 h6 motor ? I would post a pic but for some reason it says i cannot...

no one huh?

If you go here: http://www.main.experiencetherave.com/subaru_manual_scans/2000+_Legacy_FSM/

Go to wiring section. It starts with the 4 but half way through goes to the 6 cyl. section.

Hope this helps.

For future ref a lot of the '02+ manuals are the same.

Here's an H6 but couldn't find AC in it.

http://bustedfingermotorsports.com/forums/viewtopic.php?f=18&t=211&sid=e107124d83905c4fb07de0b0ca7999c9

 

O.

Thanks!