Jump to content
Ultimate Subaru Message Board
LilLink1

carburetor questions

Recommended Posts

Hey everyone new here and also pretty new with a carburetor. I had my carb rebuilt and now i need to adjust it. I found the screw in front and thought that was it i adjusted it to get idle right now its getting to much gas so assuming that was the air/fuel adjustment. So ppl saying to get to the others i need to remove the roll pin. My questing is where is the roll pin and what does it look like. If anybody has a pic or can have detailed instructions that would help a lot. Thanks

Share this post


Link to post
Share on other sites

need to know what carb and motor.

 

the roll pin covers the air fuel mixture screw.  if you have a stock Hitachi then its in the center bottom of the carb.  the idle screw will be on the linkage on the passenger side of the carb.  those are the only 2 adjustment screws (assuming you have a stock carb)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×