Tonight my rear end dropped out of the brat. Both bushings in the rear end hanger bar failed and the whole assembly just dropped, leaving the nuts and washers still on the studs. I have it rigged for now with some iron plates at the bottom so the rear end can't fall off again. Is there a source for those bushings?

622004020 - Subaru part number.

 

I have the label right there, lol.

 

Confirm in my thread if these are what you speak of though:

http://www.ultimatesubaru.org/forum/topic/130804-ocds-1980-brat-the-squirrel/?p=1112749

That one that you put on the 20 ton press is it. Thanks for the info! Do you remember where you got them?

My wagon needs them too. Aren't these also going into the early 80's - gen II ?? Or no ?I had my wagon off the ground for some tire/wheel work and they're seperating. I'll post the pic tomorrow.

 

But , yes , where do we get them? Can we send a mustache bar out to someone who sends it back with urethane?

622004020 - Subaru part number.

 

I have the label right there, lol.

 

Confirm in my thread if these are what you speak of though:

http://www.ultimatesubaru.org/forum/topic/130804-ocds-1980-brat-the-squirrel/?p=1112749

Thanks for the part numbers. Just ordered them. Glad to see these parts are still available.

My wagon needs them too. Aren't these also going into the early 80's - gen II ?? Or no ?I had my wagon off the ground for some tire/wheel work and they're seperating. I'll post the pic tomorrow.

 

But , yes , where do we get them? Can we send a mustache bar out to someone who sends it back with urethane?

Splitting....You're lucky. My rear end fell off.

Anybody order these from a dealer?

I did

Got my new bushings installed in my moustache bar today. So nice to have those fresh bushings in there. Hopefully they will last at least another 20 years.

Glad ya got that done!  Easy to do by yourself though.