Skip to content
View in the app

A better way to browse. Learn more.

Ultimate Subaru Message Board

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Featured Replies

Hi, been working on my 84 Brat. I have two issues. The ignition key cylinder get stuck and when I try to start it takes a few tries of turning the key cylinder and holding to get it to work, do I need to replace the whole cylinder or is there a switch? My oil pressure guage rises when I turn ignition on peggs out at top but then falls down and does not register, switch out oil sending unit and does same, car runs fine , think there might be a wire bad ground any ideas where to start, , thanks Ray in Seattle

The ignition switch itself is seperate from the tumbler and is attatched too it on the other side of the column. Did you use a new sender for cars equiped with a gauge? Its larger than the small switch for cars with a light. What you describe ssounds a little like you might be using a switch for cars with an oil light. If the wire feeding the gauge has grounded out for some time it has likely ruined the gauge. When you turn the key on engine off that gauge should not move. If it is (and u are using the correct sender) its getting ground from somewhere it shouldnt be. Unhook the wire and pull it out away from the engine and turn the key on. If the problem is still there then its the gauge or a problem deeper in the harness.

  • Author

The oil sending unit attaches to the block, I ordered a unit for a guage not light and it was to big of threads, only the sending unit for light fits on the block,I remember my 86 brat sending unit used the guage one, do you remember if it mounts to the block or oil pump? The threads or to big and it won't fit in space on block.

my latst oil pressure gauge for EA81, the sender came with an earthing terminal as well as the to gauge terminal to ensure good earthing for any application I suppose.. I think I also got same function as you with a gauge due to the poorly marked back case - I hooked up wires incorrectly. I think a T looked like the earth symbol ?? Rejigged works fine now :)

Correct, the larger gauge sender screws in to the bottom of the oil pump. Ive only seen them with one wire.

Edited by ihscout54

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.