kgrove56 Posted October 22, 2015 Share Posted October 22, 2015 I have a problem with the electrical side of the switch. I ordered a new won on eBay but didn't pull it apart till the other day and they look alike except for my switch has the wires sodered to the back and the new has spades for a plug in. Looked online mine is not available. Will the new switch work if I find a plug to fit and wire it? Look like there may be clearance issues or should I cut the spades down and try to sodder the wires to the new switch. Has anyone run into this problem? Thanks Ken Quote Link to comment Share on other sites More sharing options...
dfoyl Posted October 23, 2015 Share Posted October 23, 2015 Pretty sure the ignition switch for tilt and fixed are different, my fixed column had the spades on the back for a plug-in design. Quote Link to comment Share on other sites More sharing options...
kgrove56 Posted October 23, 2015 Author Share Posted October 23, 2015 Yes that part is diferent but if I cut the spades off and the excess plastic than solder the wires on I think they would be the same. Wonder if anyone has tried this? Quote Link to comment Share on other sites More sharing options...
kgrove56 Posted October 23, 2015 Author Share Posted October 23, 2015 I cut the spades off and the excess plastic solder the wires on so far working great!! 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.