kgrove56

Looking for single square headlight bezel with corner lamps for 1982 to 1984 car

I had this problem intermittently drove me nuts . Till one day it was doing it and I removed the spare tire and it went away the dam gas line was getting pinched sometimes. It had a Weber installed before I got it. Reruated the line no more problems

Anyone near there. Was a 1982 brat there in January doubt it still there. But if it is I need the headlight doors or bazels.

They had gen2 wagons starting in 1980 and 1981 the 4x4 gl had a big single square headlight with cyclops light the 1982 brat had a cyclops also but the grill and headlight bezels are different than the earlier years. Would be nice if there was an easy way to share pictures on this site I could show you.

1982 brat has single big square headlight the bezels are different than the earlier single square headlight models

No I think 1982 to 1984 wagon , 1982 to 1987 brat, hatch 1982 gl 1983 to 1987 square single headlamp dl. I don't know where the round dl headlight goes maybe 2 wheel drive and the single square 4 wheel drive? Maybe some one knows?

Looking for the large square single headlight bezels, doors,surrounds what ever, must be 1982 or later with parklamp, right and left side

The radiator support is different bot you maybe able to modify

I think you can get a discount if you buy online auto zone or somewhere. Better than getting the eBay stuff that they don't know what it fits. I got shafted! And that's the edys part # I got on eBay that didn't work in my brat 1983 to small 7"7/8 mine was 8"7/8

The eBay one is the smaller disc 7"7/8 for a 2 wheel drive I assume I bough one

You can get one from advance auto and orilily for around 120 they can look up the dimensions.

I cut the spades off and the excess plastic solder the wires on so far working great!!

Yes that part is diferent but if I cut the spades off and the excess plastic than solder the wires on I think they would be the same. Wonder if anyone has tried this?

I have a problem with the electrical side of the switch. I ordered a new won on eBay but didn't pull it apart till the other day and they look alike except for my switch has the wires sodered to the back and the new has spades for a plug in. Looked online mine is not available. Will the new switch work if I find a plug to fit and wire it? Look like there may be clearance issues or should I cut the spades down and try to sodder the wires to the new switch. Has anyone run into this problem? Thanks Ken

The fan kicking on?