I have a 1984 1800 4WD subaru BRAT, MV 

 

I need a rear wheel brake sylinder and do not know what to order. rockauto has tree different sylinders.

I have two single tapered roller bearing with a spacer between. Not the wheel bearing rockauto has.

 

can someone please tell me what I need, part numbers, and where to get it

 

attach file wheel bearing

The aftermarket wheel bearings have the roller surfaces as one complete unit, the spacer on the axle is typically built into the bearing eliminating the extra rings - basically making a 6 part bearing into a three part bearing package.

 

It's the same kit at the L series. No part numbers from me I'm sorry.

 

As for the brake slave cylinder - I just go with what my parts store gives me for my year of vehicle. Just make sure you do both at the same time with the same part number and you can't go wrong.

 

Cheers

 

Bennie

 I have the three part singel bearing. and it do not fit my car. two different ways to mount wheel bearings. My rear wheel setup is more like front wheel setup. where you push the bearing from both sides with a sleeve between. I use two two single tapered roller bearing with a spacer at the rear, in front I use two ball bearing with a spacer. I can not find any number on the bearing,

 

brake sylinder. Problem one, no dealer in norway have it. Problem two. rockauto have thee diffrent 11/16, 5/8 and 3/4. 

my rear wheel bearing setup looks somthing like this

 

 

If you have a 4wd Brat, You're wheel bearing is nothing like any of your above pictures.

 

The 6 piece bearing has been superceeded to the large, 3 piece roller.

 

You need to remove the rtainer ring at the inner side to remove the bearings and stub.

 

Then press the stub through the 3 piece roller.

 

then press/hammer, the bearing and stub through the back side of the swingarm.  Reinstall retainer.

 

you need a bearing like this  www.ebay.com/itm/For-DL-Brat-FE-GF-GL-GL-10-GLF-Loyale-RX-Standard-XT-Rear-Wheel-Bearing-New/361740436262

 I have the three part singel bearing. and it do not fit my car. two different ways to mount wheel bearings. My rear wheel setup is more like front wheel setup. where you push the bearing from both sides with a sleeve between. I use two two single tapered roller bearing with a spacer at the rear, in front I use two ball bearing with a spacer. I can not find any number on the bearing,

 

brake sylinder. Problem one, no dealer in norway have it. Problem two. rockauto have thee diffrent 11/16, 5/8 and 3/4. 

I would not trust roach auto! but I have always thought that you can rebuild the wheel cylinder.  Plenty of rebuild kits on Amazon.  It is interesting to know if it works.

 

Good luck,

Sam