Hi

I am new here. This my first post and all.

 

I got a 93 Legacy with about a gazillion miles on it and the 'check engine' light comes on once in a while. I tried to read those codes but I am not sure I have disconnected the correct connector to activate the "U-check mode".

 

I found one on the right side of the steering column that is black. If I disconnect that the fasten seat belt light flashes. Oh well..... There is also a blue one inthe same general place but I haven't gotten any response from that one.

 

Any help would be great.

 

Thanks

Actually you have to connect a connector. There should be a connector (either green or blue) that has a single wire leading to it. When it is connected, the 'Check Engine" light on the dash will flash the code to you.

 

This should be move to 'New Gen' section.

Okay I found the info thanks to Josh [Legacy777] on his web site surrealmirage.com/subaru. That's a very nice write up Josh.

 

I didn't know I had a newer Subaru. Sorry.

Welcome