SVX_commuter Posted July 19, 2004 Share Posted July 19, 2004 Hi I am new here. This my first post and all. I got a 93 Legacy with about a gazillion miles on it and the 'check engine' light comes on once in a while. I tried to read those codes but I am not sure I have disconnected the correct connector to activate the "U-check mode". I found one on the right side of the steering column that is black. If I disconnect that the fasten seat belt light flashes. Oh well..... There is also a blue one inthe same general place but I haven't gotten any response from that one. Any help would be great. Thanks Link to comment Share on other sites More sharing options...
Dr. RX Posted July 19, 2004 Share Posted July 19, 2004 Actually you have to connect a connector. There should be a connector (either green or blue) that has a single wire leading to it. When it is connected, the 'Check Engine" light on the dash will flash the code to you. This should be move to 'New Gen' section. Link to comment Share on other sites More sharing options...
SVX_commuter Posted July 20, 2004 Author Share Posted July 20, 2004 Okay I found the info thanks to Josh [Legacy777] on his web site surrealmirage.com/subaru. That's a very nice write up Josh. I didn't know I had a newer Subaru. Sorry. Link to comment Share on other sites More sharing options...
Legacy777 Posted July 22, 2004 Share Posted July 22, 2004 Welcome Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now