Front wheel bearings adjustable?

[DLGL8388]

Hello people.  Long time, no problems with the old GL.

Can I take the play out of front wheel bearings on my '88 GL by tightening the axle nut? Is that what that sleeve inside the hub is for? For the bearing to tighten against?     Bearings were replaced ten years ago.. 

[bushytails]

No, the fronts are not adjustable.  If you have play, and the axle nut is not loose, you need new wheel bearings.  If they only lasted 10 years, they either didn't have enough grease, weren't repacked often enough, or got water in them from bad wheel seals.

[SuspiciousPizza]

I'd recommend buying the sealed wheel bearings. Then you remove one seal from each bearing and face the unsealed sides inside the knuckle. Pack the inside of the knuckle with grease like normal. 

That way you don't have to worry about installing the seals. 

Installing the front bearings with the right tools is a cake walk. Installing the seals can be a challenge. Unless you're a heavy equipment tech, I don't know who'd have sockets that large to install the seals. 

[bushytails]

I found a $7 walmart oil filter socket (the many-sided polygon that fits certain brand oil filters) that was the perfect size for my gen2 wheel seals, and the thin wall fit around the seal lip perfectly.  I've never done gen3 seals, but it's an idea you might check for a seal driver.