Jump to content
Ultimate Subaru Message Board
Sign in to follow this  
ahalseth

Change piston rings on 1999 Legacy

Recommended Posts

Hello!

 

First: I have to change piston rings on my 1999 Legacy. (The new model). I have dismantled the cylinder heads and I wonder if I have to split the engine to take out the pistons.

 

Second: Do anyone have a desciption how I shall tighten the bolts of the cyliner heads. (sorry for bad English. Norwegian you see)

 

Greetings from Norway

 

Arne

Share this post


Link to post
Share on other sites

Actually, you have to remove the pistons before you can split the block. However, since you've got it this far apart, I would highly recommend taking it the rest of the way apart and putting in new bearings. To remove the pistons, you must pull the pins out through the holes in the sides of the block. On the older motors there were plugs that you had to remove, but I'm not sure how it's done on that engine.

 

Sorry, I don't have a headbolt tightening diagram on me. Any service manual for the car should have that in it.

 

Best of luck to you! (BTW: You speak better English than lots of people over here do:grin: .)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×