So I have finally found a '95 legacy that was smashed in the back. I am going to pull the engine out and swap it into the Brat. I have read most post on this board about the swap and from that have gotten a general sence of direction I want to go.

 

I would love it if someone restated just for my reassurance what I need to pull out of the 95 legacy to comeplete the swap.

 

I also had a question where I should adjust the holes in the current crossmember for the EJ22 mounts or use the legacy crossmember and somehow bolt that on the the Brat frame rails?

 

What parts of the wiring harness do I need to keep? Anything other then the ones attaching to the engine?

Please, Please do a search you will find all that you are looking for, and will make everyone like you better.

Sent a pm