jelly man Posted December 24, 2005 Share Posted December 24, 2005 The strut mount on my 92 4wd legacy sedan is broken. The rear suspension was just swapped from a 4wd wagon. I still have the old 2wd struts. They bolt to the knuckle above the hub on the 2wd and in front of the hub to allow axle room on the 4wd. Other than the stronger cartridge on the wagon are these struts interchangeable? Link to comment Share on other sites More sharing options...
Legacy777 Posted December 25, 2005 Share Posted December 25, 2005 4WD & 2WD rear struts are not interchangable. Link to comment Share on other sites More sharing options...
jelly man Posted December 25, 2005 Author Share Posted December 25, 2005 I can get some 4wd wagon struts from a friend. The FSM says they are the same length but stiffer. Will they fit? Link to comment Share on other sites More sharing options...
Legacy777 Posted December 25, 2005 Share Posted December 25, 2005 Firstly, the FWD struts are inline with the axle. The AWD ones are offset back and raised slightly. Therefore height will be different. The AWD strut body is smaller. However irregardless of height, the way the metal at the bottom of the strut is bent will not fit on the rear FWD spindle. I tried it when I did my AWD swap. I was just going to use the rear AWD struts on the rear FWD spindles on the donor car, so it rolled. I ran into the issues I mentioned, so I had to swap the rear AWD springs on the rear FWD struts, so they would bolt up to the rear FWD spindles. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now