Jump to content
Ultimate Subaru Message Board

2.5 to JDM 2.2 wiring question


Recommended Posts

So I pulled the oil pan off my Outback (98) after the engine sounded like a blender full of bolts and found large chunks of metal shavings (non aluminum, checked with a magnet), about 1/4 cup full. So I decided to put a 2.2 in rather than take the time and $ to find out if I have a boat anchor. Checked around and found the best deal for a 2.2 was a local JDM shop (JDM Enterprises in Philly).

 

Got the motor home went thru changing wire harness from the 2.5 to the manifold of the 2.2. Everything hooked up except the wires from the EGR solonoid ( brown, left/ back, under manifold) and the purge control valve (black, right/ back, under the manifold).

 

Question: Is there a solution? Do I need to go round up a US 2.2 manifold with the harness? Should I pull the heads from the 2.5, use the old Manifold and hope for the best? (I did this cause gas here is right around $3.00)

 

Any suggestions????

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...