Ok. I had a terrible vibration coming from my front end, passenger side wheel area. So I replaced the bearings...nothing. So I took the halfshaft out and put in a stub to see if it was the axle (and why not, RWD could be fun). I went to move in RWD...and it just popped out under load. I have the lever ALL the way up in Low (Not in between Hi-lo.) and it pops. It pops out in hi 4wd too. I'm trying to figure out WTF is going on. Any ideas?

 

EDIT: 5spd D/R not AWD.

 

Thanks all,

Justin.

 

P.S. This is my first post on the .org site. Damn people and their greediness.

Not sure what your problem is, but did you take both front shafts out? or just one side?

Just one. I've seen it work like that before. Just not for me.