I get the slip joint idea, what I meant was could you elaborate on this statement. How can you use the outer joint as an inner?

 

you could, but you'd need to put a slip joint in the middle, otherwise you'll hyper-extend them in a heartbeat. me and a few buddies are looking at doing something like this...

Please elaborate on this also. Where is the retaining bolt?

 

there's an external 10mm torx bolt in the bottom of it.

I get the slip joint idea, what I meant was could you elaborate on this statement. How can you use the outer joint as an inner?

 

I don't know, that part wasn't my idea....I just know that if you replace the double offset joint on the inside with a second constant velocity joint, you'll need to add a slip joint. the whole point of having a double offset in there is so it'll telescope.

 

 

the stub's retaining bolt is in the center of the stub shaft.