Are all EJ flywheels interchangeable?

 

I want to put an ACT Streetlight from a 2003 WRX in my '90 EJ22-NA Legacy, Kosher??? :-\

Edited March 26, 200917 yr by who1981

If you have a 90 legacy then your engine would most likely be an ej22. All n/a legacy have a push type clutch while turbo vehicles, for the most part, have pull type clutches. This means that a 2003 wrx clutch KIT will NOT fit a n/a 90 legacy.

If your car is AWD and it's just the clutch DISK then that might work using your stock flywheel and pressure plate, but be warned the wrx clutch disc is 5mm bigger in diameter than the standard N/A clutch disk; 230mm vs 225mm.

HTH

Kaz

a 2003 wrx clutch KIT {Must acquit! errr...} will NOT fit

 

Thanks, but I know all about the push'n and pull'n of turbo vs NA EJs. If you read my message you may note that I was inquiring about FLYWHEELS.

 

Specifically the ACT StreetLite from a WRX. I just wanted to confirm that it will pop into a 90 NA EJ22 without incident or Mods??? zzz I suspect the answer is yes...

Edited March 27, 200917 yr by who1981

In my research all I could find with the swap is that they were all turbo EJ's.

http://bbs.legacycentral.org/viewforum.php?f=7

 

And never never ever mistake a EA for a EJ again

And never never ever mistake a EA for a EJ again

 

Oops, guess that's what I get for posting after 3AM

EJ EJ EJ