I've been pulling my axles for a tranny swap, and well, I accidentally pulled the

axle stubs out with the axles.

The tranny is shot so I'm not too worried about it, but I need to reuse the

axles for my other tranny. :-\

So, how am I to go about removing the stubs from axles?

Oh, and the axles are still attached to the hubs.

I figured, why bother pulling the axle off the hub when I'm just going to put it

back on?

Thanks in advance,

 

Twitch

 

PS: The axles for the manual and auto tranny's are the same, right?

Axle to stub shaft is held together by a roll pin, just drive it out.

 

The stub shaft to trans is held in with a circle clip, just make sure its there and in good condition and then pop it back in.

 

Yes the axles are the same.