Well, I got it all together, Everything's streight and fixed... and mounts... http://usmb.net/gallery/album107 check out the newest album, it has pictures from today after I completly assembled it. Everythings bolted on! However, I ran into a new problem. When it runs for a good 20 minutes... the oil pressure runs 50psi-75psi (runs into the 75psi range when throttle hits 1,500 or higher) Suddenly drops to 0psi... and then the engine kinda makes a low rumble kinda soft clunking sound, when it idles... now if it was a shot oil pump, I was thinking it wouldn't work at all.... Anyone have any ideas what it might be? Any info is as always much apriciated. Thanks

bump?

Oil pressure regulator?

Dare I say there isn't any oil in the motor?

do you have the right amount>? if it is low the higer rpms it my be sucking air just my thought

try changing your oil cheap and quick

They just put the motor in a little while ago I watched them put oil in it.

Well actually it has just barely a little to much oil in it, it's about an 8th inch past the full mark on the dip stick. so theres an oil pressure regulator in there someware?

Also if I rev the engine up to about 3,000 rpms, the oil pressure does barely lift off of zero, barely..... it gets no where near 25psi.