Figured I'd start a new thread in an appropriate forum for this...
The harness/ECU both came from the same car. 1995 Legacy, auto.
They were stripped and installed by a VERY knowledgeable board member with plenty of experience, who is also VERY busy running his new business. I have the skills and abilities to handle this with the proper advice/direction.
I am getting codes for no EGR signal, no communication with the TCU, and cooling fan relay failure. I believe I have grounded the correct pin (81). I can get pictures if necessary. I really would like to get the CEL to stay off, the car runs FANTASTIC, I have no issues with drivability. After I grounded the pin, the car starts hard when it is dead cold, like after sitting overnight, it never had this issue before. This may seem like a lot of little bits of info, it is kinda all bouncing around between my ears so I am trying to get it out in a somewhat organized manner. There is a little background in the wanted forum, that is where this started.....
Please read: http://www.ultimates...legacy-5mt-ecu/