Tims Toy 500 Posted September 3, 2015 Share Posted September 3, 2015 I'm looking to do a 4" lift (or more). I've been researching it (on usmb) for a while now. I haven't found enough info on how and where Subie owners are lengthening the steering input shaft... secondly, I'd like to make my own lift. Does anybody know where I can get a good set of plans??? (After reading the "BOSS EA-series lift kit" thread, it sounds like Bill Omlin is not making them anymore.) Quote Link to comment Share on other sites More sharing options...
Scott in Bellingham Posted September 3, 2015 Share Posted September 3, 2015 I can send you the front strut extensions, the rear is tricky as it has seperate setups for each side , steering lower connection is cut in half then sleaved with tubing and welded 1 Quote Link to comment Share on other sites More sharing options...
Tims Toy 500 Posted September 3, 2015 Author Share Posted September 3, 2015 That would be great, thanks! So.... cut the shaft between the rack and flex joint? Or do you mean closer to the flex joint/firewall side? Guess my question should have been what side to cut ;-) Quote Link to comment Share on other sites More sharing options...
Scott in Bellingham Posted September 3, 2015 Share Posted September 3, 2015 the part that unbolts , don't cut the rack or the steering colum Quote Link to comment Share on other sites More sharing options...
Txakura Posted September 4, 2015 Share Posted September 4, 2015 index the two sides of the coupler before you cut it to add the extension, Scott used to have very good pictures of that - so good I followed them and it was dead on. I can't find them. Scott can you post any? it'd really clear it up for him. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.