Allied Armament
-
Posts
25 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Store
Posts posted by Allied Armament
-
-
Please send me redesign specs and I will make the changes for the next run on the EA 81 lifts. The EJ outback lifts have never had a problem their tuff so no worries there.
BUMPERS WILL NOT BE SOLD RIGHT NOW.
do your lifts for EA81 still have the same design with round rear lift blocks and non guseted shock exstentionsmustach bar bolts need to be longer they have about a 1/4 inch of thread in the metal
There is a definate camber problem as well you need to adjust your angle cut on front strut mounts
if so I would spend some time on a redesign because round blocks shift and roll front to back and side to side
causing your mustach bar to bend and your drive axel in the rear to pop out making 4wd useless
also the blocks shift causeing the bolts to break and it destroys the mounting points on the car itself
also the round blocks are just small enough that they press them selves thru the sheet metal on the body making your car schrink each time you use it
I had to redesign the rear end and weld new 1/4 in steel plates for the new assemble to sit on and put new bolt mounts on the plates before welding them on to the body
So basiclly the old desigh has desroyed my brat if I did not have a shop or fab exsperiance this would have totaled my brat because the stock rear suspention assembly would no longer stay attached to the car
So fair warning
feel free to pm me with questions
also I sold three of these lifts to my friends from the first group buy
they have all failed from the same problems
This is not the first time I have discussed these problems with AA I spoke to ALBIE many times his final answer on the problem was
"there is not enough money in the old suby stuff so we are not going to redesign"
Im not tring to start a fight here I just want everyone on the board to be aware I said nothing for so long cause AA stopped selling this stuff before it failed
I have only delt with ea81 and ea82 kits from AA
Ea82 kits have yet to devlope problems as far as I know ELTORO and ninja ben have used these lifts for a while
Thanks LT
-
Allied Armament is proud to announce that we are manufacturing a small run of parts for the Subaru market.
The parts included will be 15” EA 81 and 82 Wheels for the off-road enthusiast, EA 81, EA 82, and EJ Outback lift kits, EA 81/82 steel EJ to EA adapter plates, and skid plates for EA 82 4 inch lifts.
Prices are as follows:
EA 81 Lift kit 4 inch: $400
EA 82 Lift kits 4 inch: $375
EJ Outback Lift Kit 4 inch: $650
EA81/82 Wheels 15 inch: $300
EA to EJ Adapter Plates: $150
Skid Plate EA 82 4 inch lift only: $199
All prices are flat rates and orders are built to order so expect a 1 month delay in shipping from May 15th. Shipping is not included in the price.
To order please post below and I will contact you through pm.
Payment options are as follow: All Major Credit Cards, and PayPal.
For a look at our products please see our website at: http://alliedarmament.homestead.com/SubParts.html
Purchase dates will only be good from May 3rd until May 15th after those dates there will be no more sales.
Thank you for looking,
James Malarkey
Allied Armament www.alliedarmament.com
-
CMiller just showed me a short DVD he made for the Monster Subaru's maiden voyage, it was pretty sweet. I'm looking forward to Albie getting rid of the small bugs (aka weak parts) in the car and beefing it up! It should be extra entertaining next time.
-
This is Albie with Allied Armament. The mud run is in St. Hellens Or. this saturday. Go Hwy 30 w to St Hellens take Pitsburg Rd follow road to Yankton school follow rd around school. Keep going it will turn to gravel. Follow a few miles until you see mud run to the left. Huge hill climbs, mud tracks, and one huge mud hole only the big boys can play in. I dont know if I'm big enough yet, but still growing. call me at 360 903 3801 or see ya up there. :banana: :banana:
-
Chris PM Box cleaned, hit me up. I'm in Australia right now, so calling and checking messages won't be any good for a couple days when I get back. I'm sending a pm your way now.
-
Is anyone interested in purchasing new EJ Dual Range Transmissions? I am in Australia right now and I've found a supply of them not many though but enough to warrant importing them. These are not the week EA transmissions but the full blown new mfg subaru manufactured EJ Transmissions meant for the 250 Horsepower outback. They most likely will included a rear diff with the transmission for correct gearing.
Cost will be about $2500 a transmission and diff assembly. I will not import them if there is no interest
-
The cars up and running and ready to rip! Albie has already ran it several times and says its solid as a rock.... Can you say 40-50 foot roosters ! Qman your right Albie should bring a trailer i've seen him drive too , its gonna be good.
Remeber the event is on the 24th of february. Lifted Subaru Races will be held!
-
Exactly when those tires start spinning it aint gonna stop. If a stock Subaru can climb the hilll at our facility, this thing will climb just about anything! Once its up and running though only time will tell, never the less the fun will have will be worth as many axles as it takes!!! I LUV U PUL IT JUNK YARdS, and axles don't take longer than 20 minutes to change if you know what your doing!
-
Just watch out when you see this thing on the trail because the driver aint slowin down for your grahma or you. Albie already dropped a nasty exhaust and bumper system on it and let me tell you that the bumper is for pushin pus5Y's off the road.
-
Its dual range! It has an EJ to EA Adapter on it and I think a centerforce clutch.
Albie will have to get on here to answer the remainder of the questions.
-
Don't worry kid's Albies giving her two extra inches. Skid plate will be on in a few days. These are just the prepictures to get your pants wet.
Remember on the 24th were hosting a MUDRUN and a Product Demonstration at http://www.sthelensmudrun.com/sthele...un/indexx.html
This will include guns and subarus! Were going to try to hold a Gymkhoba (sp) lifted subaru race.
-
-
Alright ladies its been a while since I've posted on here and its mainly because we haven't made any Subaru products for quite sometime... Now that doesn't go to say that we don't play around with them every now and then. Albie still has the Subaru bug, and he acquired the most knarliest subaru ever, the ruu was already modified but Albie made it a little more. It started with an 89 touring wagon that now has a 4 in lift, 02 wrx engine (stand alone computer),3 in downpipe, low range W/ a spec racing clutch, and topped off with 33" x 10.5 boggers on 5" off set wheels. finally Albie is about to start it. Albie is the man! do not miss it at the St. Hellens mudrun on the 24th of february. go to http://www.sthelensmudrun.com/sthelensmudrun/indexx.html
-
From what I know I think we are completely out of the offroad wheels.
-
15's will fit without a lift not sure how large of tires can fit.
-
Spiffy, the look sweet in white. I will have to get you a photo if I can.
-
Contrar my friend, my employee just sold his subaru to a kid who wrecked it two days later! If you need instructions call us up. 503-543-5154 or email me. Make sure to tell me what year and type of vehicle.
-
$500 and (i'll throw the last rim in for free).
-
Nice job, the biggest defense for mud bogging now, other than lack of power, is a skidplate. someone here used to and still can make them
-
This is a great product. We ordered five of them last time and everyone of them fit perfectly. Feel comfortable buying from 88hatchmonster, quick shipping and easy to deal with and on top of that its a great product.
-
All of the lifts shipped last week. If you do not receive yours this week please contact me/ the shop at 503-543-5154.
-
Have any of you guys called the NUMBER
503-543-5154 to get a status from Albie???
-
I am about the most worthless person to ask about this kind of information. I have no knowledge of when things ship and such, the person you need to ask is Jason, or Albie at our shop. Please call them and ask 503-543-5154.
Just so you know I am the Majority owner of the company, and I do put together the majority if not all of the advertising for the company but as of the last year I have not worked there in a full time basis because I am finishing my Degree at Oregon State University, for which I am proud to say will be earning next week...
Anyways, Call or email them. The phone number is above the email is allied004@centurytel.net
-
I'm not a around the shop right now but if you call in and ask for a new sticker you should be able to get one sent to you. The best person to talk to is Albie, but Jason usually answers the phone.
Allied Armament's old buy thread, you all got your stuff yet?
in Products for your Subaru
Posted
If I can get five people interested in Outback bumpers I'll build them for $650 a piece. I wish I had a current photo on here of it with the light bar on it, it looks even better!