Subieguy165

Was gonna put a stroker kit in it too

95 2.2 not sure of the 2.5 have to check the vin

Have a 2.5 block and a full 2.2 motor what do I need to know to make this as easy as possible???

Thanks guys for this it's been more helpful than what I've tried to find

Anyone out there actually have some REAL feedback from these guys before I even think about trying this

Mine does the same it's just the way the ecu is trying to keep the motor going fast enough to transfer the power to the tranny to try and keep the same speed when under load/No load

I used a 3 leg bearing or pulley puller came right out after dropping the rear diff and an impact is about the only thing that would torque it enough

Made some changes from y'alls input and had some vents laying around and thought I'd use them

So it might be better to ground the pin in the stock ecu to make it read in manual mode

Found full donor car with everything but 2blown heads what should I do for the best results I know how to swap the parts and not to use 1 auto trans plug and the 4 pins on the other but can I change ecu to the auto harness???

Yes something to do

Have an update he silicone collars on all the joints now and the ends of the pipe as well

Can I get some thoughts on this intake short ram tube I made

Got a chromoly crewmember my friend made for me

Just know it's a 2nd gen 98 legacy

Thanks guys

Anyone in the new river valley have a used 1998 year or close to it 5 speed and rear end?

So a ej208tt won't fit but would a ej207 with the single turbo?

Would a twin turbo ej22 fit and drop in my legacy engine bay without modification

Fixed sparkplug hole finally

Well the m14-1.25 is the inner size just can't figure out what is the outside so I can tap the head correctly

I've done just about all of these things as well as timed the car myself with the waterpump change

Just looking for upgrades that won't require to do extensive work to do

Car has 280xxx miles on it and it just didn't engage fully one day and I touched the gas and then cluncked into reverse it's a 98 legacy ej22e and it new to me just started to do this after it cluncked in reverse and I've just made.sure from now on to wait till it makes a light click sound and then go

Have a oem fix-a-thread helicoil set and I don't know what the outer diameter is for a tap can someone help me out? Part number - 25648