I've had a somewhat scraping/binding/wheel bearing hum for a while now and it hasn't been until recently that it seems to have gotten louder. To me it sounded like bearings as the humming became louder around left hand corners. The Scraping binding noise only happened when I was off the accelerator and just coasting along. As soon as I accelerated and took load off the front wheels the sounds went away.

 

So today I replaced both bearings and inspected everything and could not see what else could cause the noises i've been experiencing. Sadly it is still making a scraping/binding noise and I cannot for the life of me figure out what the hell it is. Could it be driveshaft related?

Have you checked to see if the axle nut is tight?

We usually tighten them up to 150ft lbs + (I know the manual says 145ft lbs)

Alright you were right on the money with that one. Noises all gone

 

 

Whow... Good shot Turbone!

 

Always pays to start with the simple stuff huh?