99gtott Posted July 27, 2010 Share Posted July 27, 2010 So i've done a few swaps and i'm familiar with what goes where but late last night/early this morning i was rushing to finish a 2.2 swap and i crossed the two rear drivers side heater hoses! i drove it to work this morning, it did not overheat but felt slugish/sounded funny and now i've got a coolant leak coming from somewhere on the drivers side head/intake! i've got a day off so i'll dig a little deeper but any ideas about where i should be looking? please tell me it's just a intake gasket failure.. the motor is a phase1 2.2. and ya i know..bad rookie move! thanks! Link to comment Share on other sites More sharing options...
GeneralDisorder Posted July 27, 2010 Share Posted July 27, 2010 Swapping the heater core hoses does effectively nothing except reverse the flow through the heater core. Not a big deal and probably unrelated to your leak. GD Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now