Hello,

 

 

My 90 Sub Legacy Sedan was in a minor but major accident. I have all the replacement parts, two fenders and replacement bumber absorber and bumper cover. It was hit in the drivers side front end. Some people say that it can be pulled back out with the new fender to reference. My question is that the radiator support and the support that the hood lock is on is welded. If pulling dosen't work is there a way to replace that welded things or am I looking at a lot of work ect. I have all replacements which I suppose would mean unwelding from the other car.

 

 

 

any advice would be appreciated.

 

 

Thanks,

 

 

Tim

If the core support is bent beyond repair.. you will have to cut the straight one from your parts car and weld it in.. just make sure your frame rails aren't bent as well... Not worth fixing at that point.. unless you really have a special attachment to that car..

You might be in luck. There are currently two early Legacys at the Lynnwood Pull a Part with straight front ends. It would be a source of straight parts for you if you need them. Rent a portable sawsall and you're good to go.

yeah if the core support is bent beyond bending it back....you'll need to cut the old one out and weld a new one in.