Jump to content
Ultimate Subaru Message Board
elshtobito

Opening DIY garage...need some feedback

Recommended Posts

Funny this came back to the top - I just had a customer come in asking for advice with his exhaust install after spending a whole bunch of hours at one of these DIY garages - him and his friend ultimately failed to get his turbo-back installed due to not being adequately prepared with knowledge and tools - broken exhaust studs/nuts ensued and it was an expensive catastrophe. And this was on a 2016 WRX. 

 

GD

Share this post


Link to post
Share on other sites

Just stopped by one here in Portland, Oregon... not too shabby guys been in business for a couple yrs now. Gots everything ya need. 5 star reviews.

 

https://m.facebook.com/oregongearheadgarage/photos/?tab=album&album_id=1852197501701579&ref=page_internal&_rdr

If ya haven't already done research what tools ya need layed out it may take a few extra. I.E. doing your wheel bearing axles?? pre-pack your bearings, preset torque wrenches 3 pcs. 1 balljoint castle nut, 2 Axle nut, 3 lug nut ???? could do the job even faster with a friend ????

Edited by Len Dawg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×