so i have a 92 loyale with a two inch lift that is killing axle boots daily. i was going to drop my engine x member my radius rod and my tranny x member 1 inch along with extending my steering shaft 1 inch. i can not figure out how to drop the tranny x member and radius rod though. any help would be apprecated

There is enough length in the bolts to stack a few washers between the body

When I installed The SJR 2" Lift Kit for the Front of my Subaru "BumbleBeast" I dropped the Engine's Crossmember 1½" Inches to let the Axles sit as Straight as Possible; The SJR kit came with Rectangular tubes, Strong enough to be Placed between the Body and the Crossmember.

 

See: ~► http://www.ultimatesubaru.org/forum/showthread.php?t=117874&page=3

 

I also had to extend the Steering Shaft.

 

Kind Regards.

how much did you extend the steering shaft

how much did you extend the steering shaft

 

The same amount that the subframe spacers were.