My buddy found a 3.7 LSD, and I have an open 3.9 rear to put the guts in. I read the LSD swap thread in the off road mods section, but there's no pics of the process. I'm mainly looking for a pic of the material I need to remove from the 3.9 rear to make room for the LSD carrier, and see if there's enough space to get a cut off wheel or angle grinder in there.

Yew rook n wong prace glasshoppa ..(yes I know, completely offensive, but don't worry I don't hate anyone)

http://www.indysworld.com/80s/general/USRM/mick-usrm/lsd-swap/lsdswap.html

It is in the Old USRM, then linked by  Mick.

 

cheers

Awesome, thank you very much. It takes way more than that to offend me

I was more talking to the general public who might read it. lol

cheers

Edited March 27, 201412 yr by monstaru

I also posted a thread pic in the "new" USRM about 8 years ago.....check it out.

http://www.ultimatesubaru.org/forum/topic/63821-pics-of-lsd-conversion/

my bad on a thread jack but is where do you get the parts to rebuild the lsd third member... i cannot find the new stuff for the life of me. i have the stuff for the swap but my lsd is to tired to even bother swapping

I've got part #s here......not sure if you can still get them from Subaru though.

 

48587 7000 is the Friction Plate

 

48590 7001 is friction Disk......1.65 mm

48590 7002 is friction Disk......1.90 mm

 

48593 7001 is thrust washer 1.60mm

           7002 is thrust washer 1.75mm

           7003 _____________ 1.85mm

 

 

7220 40000 is the Full LSD assembly.

Edited April 5, 201411 yr by Gloyale

Wow!!! Gold mine!! Thanks gloyale