Skip to content
View in the app

A better way to browse. Learn more.

Ultimate Subaru Message Board

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

97 TRANS IN A 98 LEGACY WONT START HELP!

Featured Replies

I put the auto trans from a 97 legacy into a 98 legacy and now it wont start. Starter doesnt even try. I noticed some of the wiring is a little different but things seemed to all fit. 

 

(my first subaru)

 

WHAT AM I MISSING?!?!?!? also my AT fluid temp light is on for some reason now?

 

Try moving the shift selector to "N" or slightly out of Park.  If you switch is not indexed as Cougar said it will not start.

AT Temp light blinks when there is a fault code for the trans. The oil pan on the transmission is very flimsy, it is not designed to have any weight put on it. If you used a jack head under the trans pan there's a good chance one or several of the solenoids on the valve body were damaged. There are also several wires inside between the pan and valve body which get pinched easily.

 

The Inhibitor switch on the trans likely needs to be adjusted, or the cable needs to be adjusted where it attaches to the selector lever in the trans.

Did you make sure the selector was all the way in park before hooking up the cable?

  • Author

It was in park when I attached the cable. On the 97 trans it had a different selector on the trans with different wire/connector setup so took the metal one off and I switched the plastic one from my bad trans onto it. The AT Temp light isn't blinking, its just on. Its hard to push the button on the shifter. So I guess I'll see what kind of adjustments I can make?

There is usually a hole in the inhibitor switch where with the shifter in N (P?) the hole lines up with another hole and you can put a pin in.

If the holes don't line up, it's misadjusted.

 

If it has the holes.

If the car has keyless entry/alarm.........you may need to depress the reset button while turning key to "ON"

 

button is ussually mounted very hidden almost behind the and above the hood latch pull....mounted to the dash sheetmetal at it's lowest edge against the kickpanel.

If it has and aftermarket remote start or security system, junk it.

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.