I'm putting a 2.2 from a 2001 Impreza with 5 speed into a 2000 Forester with 5 speed. Do I use clutch and flywheel from Impreza or Forester.

 

Thanks

Dp

Use the one that matches the trans....but doubt it matters. ARe they both hydraulic clutches? 2.2 on earlier years was cable; 2.5 were hydro.

 

You have the single-port exhaust y-pipe for the 2.2.?

 

Td

I forgot to ask, do I need to use the cam pullies from the original forester 2.5

Yes, the EJ222 sometimes uses a MAF/MAP combo system depending on model, and the EJ251 Forester is straight MAP system

I forgot the crank pullies are different, does that matter on which one I use

Well, finished the swap, and no start. Turns over but won't start. Waiting for my son so I can have him turn it over while I check for spark.

 

This is about the 10th swap I have done a motor swap from 2.5 to 2.2 and the first time it didn't start right up:-(

Cam sprocket and driver cam pulley swapped?

Crank and driver cam pullies, yes

Does the 2000 Forester right side cam pully have 7 timing teeth on the back of it

I'm sorry, left sidecam

Swapped pullies and checked timing. It has spark and its getting fuel, but it just turns over and won't start.

 

I used the intake from the Forester, tomorrow I mat swap the intakes and put the one from the 2.2 on and see what happens.

Well, now I'm baffled. I have tried everything and still no start. I am now sitting with a 2001 2.2 motor from an Impreza 5 speed in a 2000 Forester with a 5 speed. I have the intake and pulleys from the Forester on, I have fuel (won't even start with starting fluid). I have spark, I have tripple checked the timing and I replaced the crank sensor. All it does is turn over but won't fire.

 

Anyone have any ideas.

 

Thanks