Would anybody know where I can pick up a knock sensor connector on the harness side.

Mine was pulled off right at the sealing rubber when I pulled the intake off I did not feel it when I pull it off making me think that it was not held on by much

Best bet would be pick n pull or junk yard.

Just hard wire it. If you need to pull the manifold take out the 12mm bolt. If you need to replace the sensor - hard wire it again. 

 

They can be extremely troublesome so after many years of comebacks due to poor connections we just hard wire them if they give difficulty. 

 

GD

Thanks GD that's what I did to get it running guess I'll just have to solder it

Don't solder. Use seamless non-insulted splice connectors and a proper crimper and seal it with 3M heat shrink with sealant. There's a reason that NASA and the Nuclear industry both use mechanical connections for electrical. I use to solder but it takes a lot longer and there's concerns with lead free solder cracking with age, corrosion from the flux, etc.

 

GD