I've searched for this, but i havn't found any answers so if they are out there im sorry for asking again. What settings are you guys with webers running for your float level and float drop. I have the dfev instead of the dgev, but im pretty sure the specifications for the float level and float drop will be the same. Thanks

Probably depends on which DFV you have. There are several with different sized venturi's. Is is a true DFV or a Ford version (holley 5200 series)?

 

GD

MY mistake i should have mentioned it it is a holley 5200. I have a data sheet telling the float levels and float drops of most of the vehicles using the holley 5200 non feedback carb. If nobody has a definite answer i believe i will just find a vehicle with a motor of the same displacement and use that as a start. Sound like a good idea?

Maybe leaf through a haynes manual for a 5200 equiped Ford at the local parts place..... or call a Ford dealership and ask them to look it up. LOL.

 

Sounds like your data sheet will have the answer. As long as you know the size engine your carb came from.

 

GD

i'll go ahead and try that, thanks for the quick responses man.

Try this post...... http://www.ultimatesubaru.org/forum/showthread.php?t=16892 Tim

Try this post...... http://www.ultimatesubaru.org/forum/showthread.php?t=16892 Tim

Thanks for the reply. One question though, the float measurements on the diagram are in millimeters correct am i correct?

nevermind i see it now just didn't look close enough