bmaness Posted March 10, 2019 Share Posted March 10, 2019 So I replaced the heater core successfully but when I glued it all back together the AC compressor clutch would not kick in. It was working fine before the heater core. Everything else works. At the same time I decided to remove the dealer-installed security system. So I’m figuring I have a wire not connected yet. That red one coming out of the instrument harness to fuse box 15 prong connector is my prime candidate. And help me to understand what the wires wrapped in gray vinyl go to. Some sort of round 5 wire connector above the fuse box. One of the wires goes through the bulkhead down to near the driver headlight. Fuses all good. Mode control and fan motor working fine. I jumped the compressor clutch direct off the battery and it engaged normally. Any ideas? Thanks folks Quote Link to comment Share on other sites More sharing options...
jonathan909 Posted March 11, 2019 Share Posted March 11, 2019 Yikes. Get the exact wiring diagram for your year and model. Quote Link to comment Share on other sites More sharing options...
bmaness Posted March 11, 2019 Author Share Posted March 11, 2019 I have the service manual, but my electrical schematic deciphering skills are limited. I was hoping someone would recognize where that red power wire goes by sight. Quote Link to comment Share on other sites More sharing options...
bmaness Posted March 11, 2019 Author Share Posted March 11, 2019 95 Legacy Wagon LSi Quote Link to comment Share on other sites More sharing options...
1 Lucky Texan Posted March 11, 2019 Share Posted March 11, 2019 low refrigerant ? 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.