Can anybody point me to a reliable source for 1979 BRAT mustache bar bushings?  Thank you!

Are you talking about the body side or diff hanger ones?   DIY make your bushings is an option that’s used for some of those old gen NLA bushings. 

Thanks!  I am talking about the flat discs above and below the ends of the mustache bar.  

 

Inside those flat disks with their crowns are the sleeved bushings. Need 4 of those bushings for mustache bar and lateral bracket.

Note the same crowned disks are on the ends of the diff. mount bracket. So you will need 8 of those to do a complete job. 
 

8 disks 

4 bushings

original p/n for “stopper” aka the crowned disk is 6220 10001

and the bushings p/n 6220 04020 

Maybe be worth hunting. I know most likely they’re going to be out but you never know. I see you’re up north. Back when my local was way past keeping that old stock I would have them use a west coast or other regional distributor and often I would score. 

 

 

 

Edited July 2, 20205 yr by moosens

Going forward I’d be concerned with the bracket unit which handles this whole bar and diff.

Put a good eye to those as you have the unit down. 

Edited July 2, 20205 yr by moosens
Can’t rotate sorry

This is the one (both sides) to check.

 

 

Edited September 21, 20214 yr by moosens
Media trim

thanks a ton!  I'm looking for some way to repop something....